SHER-GLASS FF
PRODUCT DESCRIPTION:
Sher-Glass FF is a glass flake reinforced amine epoxy coating formulated for immersion service or where steel or concrete protec- tion is desired, in a wide range of harsh industrial environments.
Features:
- The use of pre-wetted glass flake allows for consistent mixing
and application - Re-inforced film enhances performance and edge protection
- Excellent immersion service performance
- Corrosion, impact, abrasion resistant
- Direct to metal application for tanks and structural steel
- Up to 20.0 mils (500 microns) dry in a single coat
PRODUCT CHARACTERISTICS:
Finish: Semi-Gloss
Color: Red Oxide, Black, Haze Gray, White OAP
Volume Solids: 76% ± 2% mixed, (calculated)
Weight Solids: 87% ± 2% mixed, (calculated)
VOC (unreduced): <250 g/L; 2.08 lb/gal
Mix Ratio: 4:1 (2 components)
Theoretical Spreading Rate per coat:
| Minimum | Maximum | |
| Wet mils (microns) | 10.0 (250) | 26.0 (625) |
| Dry mils (microns) | 8.0 (200) | 26.0 (500) |
| ~Coverage sq ft/gal (sq m/L) | 61.0 (1.5) | 152.0 (3.7) |
Recommended Uses:
For use over properly prepared steel and concrete surfaces in industrial environments and water and wastewater exposures, such as but not limited to:
- Petro-chemical and power plants
- Immersion in fresh or salt water
- Water and waste water facilities
- Marine – ships, barges, and offshore structures
- High humidity and moisture areas
- Areas requiring good chemical resistance to splash, spillage, and fumes
- Acceptable for use in areas of high H2S
- Acceptable for use with cathodic protection systems
*Note: For complete product information, please refer to Sherwin-Williams Product Page.
