Sherwin Williams SeaGuard 5000 HS

SeaGuardAblative Antifouling Coating

PRODUCT DESCRIPTION:

Seaguard Ablative Antifouling Coating is an advanced antifouling coating based on a polyamide polymer containing cuprous oxide. Recommended for the underwater surfaces of steel vessels operating in all coastal and oceanic waters. This product maintains an effective, bio-active surface during its entire life.

Features:

  • Long Life
  • Brush, roll, or spray application
  • A tin-free ablative coating
  • Complies with the requirements of MIL-PRF-24647

PRODUCT CHARACTERISTICS:

Finish: Flat

Color: Red, Black, and Blue

Volume Solids: 65 ± 2%

VOC (EPA Method 24): <400 g/L ; 3.33 lb/gal, maximum

 

Theoretical Spreading Rate per coat:
Minimum Maximum
Wet mils (microns) 4.0 (100) 7.0 (175)
Dry mils (microns) 2.5 (63) 4.0 (100)
~Coverage sq ft/gal (sq m/L) 260.0 (6.4) 430.0 (10.5)

Recommended Uses:

SeaGuardAblative Antifouling Coating is for use on prepared surfaces in marine environments:

  • As an antifoulant for underwater hull and boot top on vessels operating in global trade with short to medium idle times.
  • Use on vessels with a service speed exceeding 10 Knots

*Note: For complete product information, please refer to Sherwin-Williams Product Page.

RECOMMENDED PRODUCT FOR SURFACE PREPARATION

HoldTight® 102

hold tight surface preparation

HoldTight® 102 completely removes all salts, resulting in no conductivity. It also removes abrasives and debris from the surface’s profile providing a better surface area to bond with coating.

HoldTight® 102 is the perfect surface preparation solution for industrial environments with steel and concrete surfaces, including but not limited to:

  • Sewer collection systems
  • Wastewater treatment plants
  • Water towers
  • Industrial treatment plants
  • Industrial tankage

HoldTight® leaves a clean surface up to 72 hours. Large areas of structures can be blasted and cleaned completely before coating application, instead of having to be coated immediately after blasting every day.

HoldTight® 102 can be worked into any blasting process to achieve a totally clean surface, with zero flash-rust and zero residue left behind. HoldTight® is a clear, simple additive with visible results, eliminating both natural and artificial contaminants. At sea HoldTight® 102 is safe to use and compatible with a wide variety of surfaces, including steel, concrete, fiberglass, aluminum, composites, and more!

FIND A DISTRIBUTOR