PHENICON HS/FF
PRODUCT DESCRIPTION:
PHhenicon HS Flake Filled is a VOC-compliant epoxy novolac phenolic with micaceous iron oxide. Designed for use as part of a system for internal tank lining.
Features:
The micaceous iron oxide provides:
- Improved abrasion and blister resistance
- Lower moisture vapor transmission
- Film reinforcement
- Higher temperature resistance • Improved edge protectionLow temperature hardener available for applications from 35°F (1.6°C) minimum to 80°F (27°C) maximum.
PRODUCT CHARACTERISTICS:
Finish: Semi-Gloss
Color: Reddish Gray and Light Gray
Volume Solids: 75% ± 2%, mixed
Weight Solids: 86% ± 2%, mixed
VOC (calculated): <250 g/L; 2.08 lb/gal, mixed
Mix Ratio: 4:1 by volume
Theoretical Spreading Rate per coat:
| Minimum | Maximum | |
| Wet mils (microns) | 7.0 (500) | 9.0 (225) |
| Dry mils (microns) | 5.0 (500) | 7.0 (175) |
| ~Coverage sq ft/gal (sq m/L) | 200.0 (4.9) | 240.0 (5.9) |
Recommended Uses:
- Internal tank lining for most petroleum products such as: crude oil, unleaded gasoline, most aromatic solvents, motor fuels, alkalies, and brines
- Secondary containment
- Acceptable for use with cathodic protection systems
- Acceptable for use under thermal insulation
- Acceptable for cryogenic service
- Approved primer for FIRETEX M89/02 for service operating temperatures of 176°F (80°C) to 302°F (150°C)
- Nuclear Power Plants • Nuclear fabrication shops
- DOE Nuclear Fuel Facilities • DOE Nuclear Weapons Facilities
- This product meets specific design requirements for non-safety related nuclear plant applications in Level II, III and Balance of Plant, and DOE nuclear facilities*
* Nuclear qualifications are NRC license specific to the facility. - Acceptable for use in Canadian Food Processing facilities categories: E8 (Confirm acceptance of specific part numbers/rexes with your SW Sales Representative)
*Note: For complete product information, please refer to Sherwin-Williams Product Page.
