FAST-CLAD ER EPOXY
PRODUCT DESCRIPTION:
Fast-Clad ER Epoxy is an edge retentive, ultra high solids epoxy amine coating engineered for immersion service in sea water ballast tanks, fuel/sea water ballast tanks, and petroleum storage tanks. The rapid return to service and high build, edge retentive properties of this coating provide superior protection compared to conventional epoxies.
Features:
- One coat protection
- Fast return to service
- Low odor
- Dry to walk-on within four hour
- Designed for plural-component application equipment
- Greater than 70% edge build retention
- Low Temperature application and cure capabilities to 25°F/-4°C
PRODUCT CHARACTERISTICS:
Finish: Gloss
Color: White-Base, Blue OAP, Red Oxide
Volume Solids: 100%, mixed
Weight Solids: 100%, mixed
VOC (EPA method #24): <85 g/L; 0.71 lb/gal, mixed
Mix Ratio: 1:1 by volume
Theoretical Spreading Rate per coat:
| Minimum | Maximum | |
| Wet mils (microns) | 18.0 (450) | 22.0 (550) |
| Dry mils (microns) | 18.0 (450) | 22.0 (550) |
| ~Coverage sq ft/gal (sq m/L) | 73.0 (1.8) | 89.0 (2.2) |
Recommended Uses:
For use over prepared steel or masonry surfaces in industrial and marine exposures such as:
- Ballast tank interiors and oil storage tank interiors
- Fuel storage tanks and external pipeline coating
- Primary or Secondary containment
- Acceptable for use with cathodic protection systems
- Where rapid return to service and edge protection film build properties are required
- Meets MIL-PRF-23236 Type VII, Class 5, 7, 5/18, 7/18, 13/18, 17, 17/18 Grade C requirements for single and multi-coat seawater, fuel, bilges, and CHT tanks
- Blue OAP contains fluorescent pigment
- Wind tower gearbox lining and transformer lining up to 204°F (96°C)
- Suitable for use in the Mining & Minerals Industry
*Note: For complete product information, please refer to Sherwin-Williams Product Page.
