Sherwin Williams SeaGuard 5000 HS

KEM AQUA 400 Waterborne Enamel

PRODUCT DESCRIPTION:

Kem Aqua 400 Waterborne Enamel is a high quality water reducible alkyd enamel. It offers very good color and gloss retention with sharp gloss, high DOI and excellent corrosion resistance making it an ideal coating for the Off-Road Equipment and General Metal markets.

Features:

  • 2.8 lb/gal VOC* maximum
  • Very good color and gloss retention
  • Very good one coat protection; comparable to high quality solvent based alkyds
  • Excellent adhesion and early moisture resistance
  • Sharp high gloss and high DOI
  • Resistant to diesel fuel and motor oil
  • Reduces with water**
  • Application by conventional, airless, air assisted airless, HVLP and electrostatic spray methods and by dipping
  • No critical recoat time
  • Use water to clean up equipment
  • Good flexibility and mar resistance
  • Dries hard overnight

PRODUCT CHARACTERISTICS:

Finish: 60° Gloss: 80+
20° Gloss: 10-20

Volume Solids: 25-32 ± 1%, varies by color

Viscosity: 95-105 Krebs Units, Stormer (at 77° F) 40-60 secs., #5 Zahn Cup

 

Theoretical Spreading Rate per coat:

 

Minimum Maximum
Wet mils (microns) 4.0 5.0
Dry mils (microns) 1.0 1.25
~Coverage sq ft/gal 320 530

 

*Note: For complete product information, please refer to Sherwin-Williams Product Page.

RECOMMENDED PRODUCT FOR SURFACE PREPARATION

HoldTight® 102

hold tight surface preparation

HoldTight® 102 completely removes all salts, resulting in no conductivity. It also removes abrasives and debris from the surface’s profile providing a better surface area to bond with coating.

HoldTight® 102 is the perfect surface preparation solution for industrial environments with steel and concrete surfaces, including but not limited to:

  • Sewer collection systems
  • Wastewater treatment plants
  • Water towers
  • Industrial treatment plants
  • Industrial tankage

HoldTight® leaves a clean surface up to 72 hours. Large areas of structures can be blasted and cleaned completely before coating application, instead of having to be coated immediately after blasting every day.

HoldTight® 102 can be worked into any blasting process to achieve a totally clean surface, with zero flash-rust and zero residue left behind. HoldTight® is a clear, simple additive with visible results, eliminating both natural and artificial contaminants. At sea HoldTight® 102 is safe to use and compatible with a wide variety of surfaces, including steel, concrete, fiberglass, aluminum, composites, and more!

FIND A DISTRIBUTOR