Sherwin Williams SeaGuard 5000 HS

ZINC CLAD 4100

PRODUCT DESCRIPTION:

ZINC CLAD 4100 is a three-component, polyamide epoxy, zinc-rich coating. It contains 89.2% by weight of zinc dust pigment in its dried film.

Features:

  • Meets Class B requirements for slip coefficient and creep resistance
  • Provides cathodic protection
  • Damaged film exhibits “self-healing” properties
  • Fast Recoat Time
  • Outstanding application properties

PRODUCT CHARACTERISTICS:

Finish: Flat

Color: Gray-Green, mixed

Volume Solids: 74% ± 2%

Weight Solids: 90% ± 2%

VOC (mixed): <320 g/L; 2.67 lb/gal unreduced <340 g/L; 2.80 lb/gal 5% reduction

Zinc Dust Pigment Content in Dry Film: 89.2%

Mix Ratio: 3 components, premeasured

 

Recommended Spreading Rate per coat:
Minimum Maximum
Wet mils (microns) 4.0 (100) 7.0 (175)
Dry mils (microns) 3.0 (75) 5.0 (125)
~Coverage sq ft/gal (sq m/L) 237(29.1) 396 (9.7)

Recommended Uses:

For use over properly prepared steel.

  • Bridge and Highway Structures
  • Fabrication Shops
  • Stadiums and sports complexes
  • Drilling Rigs
  • Piping
  • Refineries
  • Barges & ships
  • Shop or field application

*Note: For complete product information, please refer to Sherwin-Williams Product Page.

RECOMMENDED PRODUCT FOR SURFACE PREPARATION

HoldTight® 102

hold tight surface preparation

HoldTight® 102 completely removes all salts, resulting in no conductivity. It also removes abrasives and debris from the surface’s profile providing a better surface area to bond with coating.

HoldTight® 102 is the perfect surface preparation solution for industrial environments with steel and concrete surfaces, including but not limited to:

  • Sewer collection systems
  • Wastewater treatment plants
  • Water towers
  • Industrial treatment plants
  • Industrial tankage

HoldTight® leaves a clean surface up to 72 hours. Large areas of structures can be blasted and cleaned completely before coating application, instead of having to be coated immediately after blasting every day.

HoldTight® 102 can be worked into any blasting process to achieve a totally clean surface, with zero flash-rust and zero residue left behind. HoldTight® is a clear, simple additive with visible results, eliminating both natural and artificial contaminants. At sea HoldTight® 102 is safe to use and compatible with a wide variety of surfaces, including steel, concrete, fiberglass, aluminum, composites, and more!

FIND A DISTRIBUTOR