Sherwin Williams SeaGuard 5000 HS

TARGUARD COAL TAR EPOXY

PRODUCT DESCRIPTION:

Targuard Coal Tar Epoxy is a high build, polyamide epoxy coal tar coating.

Features:

Meets the following specifi cations:

  • Corps of Engineers Formula C-200a
  • SSPC Paint 16 Specification
  • AWWA C-210, Non-Potable Water Applications immersion service performance

PRODUCT CHARACTERISTICS:

Finish: Semi-Gloss

Color: Black, Red

Volume Solids: 74% ± 2%, mixed

Weight Solids: 82% ± 2%, mixed

VOC (unreduced): <250 g/L; 2.08 lb/gal

Mix Ratio: 2 component, premeasured 4:1
5 gallons mixed

 

Theoretical Spreading Rate per coat:
Minimum Maximum
Wet mils (microns) 11.0 (275) 22.0 (550)
Dry mils (microns) 8.0 (200) 16.0 (400)
~Coverage sq ft/gal (sq m/L) 74.0 (1.8) 148.0 (3.6)

Recommended Uses:

For use over properly prepared steel and concrete surfaces in industrial environments and water and wastewater exposures, such as but not limited to:

  • Penstocks
  • Dam gates
  • Petroleum storage tanks
  • Heavy duty structural coating
  • Non-potable water tank and pipe coating
  • Acceptable for use with cathodic protection systems
  • Liner for clarifiers
  • Marine applications
  • Off shore drilling rigs

*Note: For complete product information, please refer to Sherwin-Williams Product Page.

RECOMMENDED PRODUCT FOR SURFACE PREPARATION

HoldTight® 102

hold tight surface preparation

HoldTight® 102 completely removes all salts, resulting in no conductivity. It also removes abrasives and debris from the surface’s profile providing a better surface area to bond with coating.

HoldTight® 102 is the perfect surface preparation solution for industrial environments with steel and concrete surfaces, including but not limited to:

  • Sewer collection systems
  • Wastewater treatment plants
  • Water towers
  • Industrial treatment plants
  • Industrial tankage

HoldTight® leaves a clean surface up to 72 hours. Large areas of structures can be blasted and cleaned completely before coating application, instead of having to be coated immediately after blasting every day.

HoldTight® 102 can be worked into any blasting process to achieve a totally clean surface, with zero flash-rust and zero residue left behind. HoldTight® is a clear, simple additive with visible results, eliminating both natural and artificial contaminants. At sea HoldTight® 102 is safe to use and compatible with a wide variety of surfaces, including steel, concrete, fiberglass, aluminum, composites, and more!

FIND A DISTRIBUTOR